Grooved snubber, and post design assures center break of flexible wire up to 1/16" diameter. May also be used for testing cord, rubber or filaments. 1" diameter aluminum snubber is mounted on  swiveling plate so that specimen will align with force when load is applied.  Ball socket mounting screw in upper grip assures proper alignment with lower grip. Capacity: 200 lb; Upper grip weight: 5 oz; Combined grip length: 8-3/4"

Designed for testing filaments or extremely fine flexible wire up to 1/32" diameter. 7/16" diameter snubber is part of precision machined swiveling fixture which assures specimen alignment with force when load is applied.  All aluminum construction. Additional female adapter (aluminum) is supplied to adapt bottom grip and allow for proper alignment between grips.  Capacity: 50 lb; Upper grip weight: 1-1/2 oz; Combined grip length: 5-1/8"

Three non-locking pin design for figure 8 wrap of specimen assures center break, and permits quick installation and release of test piece.  Throat clearance with pins installed and clearance between pins are both 3/8". Throat width is 1/2". Ball socket mounting screw in upper grip assures proper alignment with lower grip. Capacity: 500 lb; Upper grip weight: 6 oz; Combined grip length: 5"

Specifically designed to test the ultimate strength of wire/terminal connections.  Upper grip consists of self-aligning wheel with 9 equally spaced slots to accommodate standard terminal shank sizes.  Ring terminals are secured with a pin, in line with the largest slot.  Bottom grip has an eccentrically mounted, self tightening knurled roller which will accept wire up to 1/8" diameter. Capacity: 100 lb; Upper grip weight: 1 lb, 9-1/2 oz; Combined grip length: 7"

For wire, yarns and threads. The sample is wrapped around the bollard and the free end clamped firmly in place. Grip stresses in the specimen are distributed in the material in contact with the bollard circumference.

This vice action grip features replaceable aluminium facing disks, plus other optional faces made of either leather or rubber for delicate specimens. This grip corresponds to the mechanical testing of steel wire per BS4545:1970. Includes upper and lower grip.

Applications
Used for tensile testing of soft wire, cord and fiber. The specimen is pulled to break and the relationship is recorded between force and extension. The test also determines other mechanical properties including:

• Elongation
• Maximum Force
• Percentage Elongation
• Stress
• Extension
• Tensile Strength
• Percentage yield point extension
• Yield Stress
• Percentage reduction of area proof stress

This pneumatically actuated vice grip is operated with a foot pedal (TG412/F) or can be specified for hand operation (TG412/H). Both grip types are supplied with standard plain metal faces (25 x 25mm). Optional jaw faces are available. The TG412 is not supplied when ordering optional faces.

Packaging: includes upper and lower grips with standard plain metal faces.

Applications: General purpose grips for tensile testing of rubber, plastics, textiles and other materials where self tightening is required

This pneumatically actuated vice grip is operated with a foot pedal (TG420/F) or can be specified for hand operation (TG420/H). Both grip types are supplied with standard plain metal faces (25 x 25mm). Optional jaw faces are available. The TG420 is not supplied when ordering optional faces.

Packaging: includes upper and lower grips with standard plain metal faces.

Applications: General purpose grips for tensile testing of rubber, plastics, textiles and other materials where self tightening is required